Table of Contents
Advertisement
6.1.6 Security menu
This allows the user to enter passwords for all security levels (except logged out), and to enable/disable serial
communications security.
Engineer Pass
Supervisor Pass
Operator Pass
Feature Pass
A
September 18
FEC920: USER GUIDE
Instrument.Security
Engineer Pass
Supervisor Pass
Operator Pass
Feature Pass
Feature2 Pass
Feature3 Pass
Comms Pass
OEM Pass
OEM Entry
OEM Status
Audit Trail
Signing
Authorisation
Login Timeout
Pass Attempts
Min Password Len
Sup Log Disabled
Passwords Expire
uuu Pass Expires
Default Config.
Figure 44 Security menu
Gives access to configuration menus. Set to '100' when despatched, but can be edited
here, if required, by entering an alternative of up to 20 characters (note 1).
If 'reset' (case sensitive) is entered as the Engineer Password, the 'Default Config.' field
appears allowing the instrument default configuration to be restored (note 2).
A password (default is '100') of up to 20 characters can be entered here to protect
Supervisor level access.
A password (none by default) of up to 20 characters can be entered here to protect
Operator level access. If the Auditor (auditor) feature is enabled, this option is not
available as Operator level access is replaced by Users 1 to 25.
This is a password supplied by the manufacturer to enable the software options (e.g.
Loop, Zirconia block, Toolkit blocks, Batch, 21CF11, etc.). When applying for this
password, the manufacturer will require the instrument's MAC address (Network.Interface
menu Section 6.2.1) and the instrument's firmware Version (Instrument.info menu -
Section 6.1.4). The password is MAC address dependent so that it cannot be used on any
other instrument.
A5E45696052A Rev-AA
**********
12345
1232
54321
Enabled
**********
Unlocked
No
Yes
No
Off
Unlimited
3
No
Off
xx Days
No
Appears only if Engineer
Password = reset
Page 53
Advertisement
Table of Contents
