Ethernet/Ip Display Mode - Siemens FEC920 User Manual

5.4.8 EtherNet/IP display mode

This display mode appears only if enabled in Instrument.Display configuration (Section 6.1.3) and is used to
display the input and output parameters assigned to the Client and Server input and output tables. Parameters
which have been configured with descriptors are identified by these descriptors instead of their 'opc' names
(shown in Figure 27).
Virtual Channel.1.Main.In-
Inputs
Outputs
Server IP
address,
Connection type,
RPI
IP address and
mode of
operation for this
unit
See
'Explicit data'
below
A
September 18
FEC920: USER GUIDE
EtherNet/IP Client
put1
Loop.1.Setpoint.SP1
Loop.1.Setpoint.SP2
Loop.2.Setpoint.SP1
Loop.1.Setpoint.SP2
EtherNet/IP Client
123.123.123.223 : Point2Point :
1000ms
123.123.123.222
Client (IO)
Explicit 1
No Connection No Connection
IO Server Configuration
Mode Client (IO)
Input Instance 100
Size (Bytes) 100
Output Instance 112
Size (Bytes) 100
Server Address 123.123.123.223
Priority Scheduled
RPI (ms) 1000
Connection Type Point2Point
Reset No
Figure 27 Typical EtherNet/IP display
A5E45696052A Rev-AA
11.1
-19.1
123.0
132.0
246.2
Explicit 2
EtherNet/IP Client
Virtual Channel.1.Main.In-
Loop.1.Setpoint.SP1
Loop.1.Setpoint.SP2
Loop.2.Setpoint.SP1
Loop.1.Setpoint.SP2
The list of parameters can be scrolled
through using the up/down arrows.
Items with green arrows can be edited if the
user is logged in with the correct access level.
IO Server Identity
Vendor Number
Device Type
Product Code
Revision
Status Word
Serial number
Product Name
Data depends on the slave.
These items appear only for the Client
17.3
put1 -12.9
123.0
132.0
246.2
111.11
45
0
E780
n.nn
0
8D01904C
Nano
Page 37