Locale - Siemens FEC920 User Manual

To set the time, the scroll button is operated to enter edit mode, then the up and down buttons are used to scroll
to display a time, say 15 seconds later than the current time. Once the current time matches the display, the
scroll button is pressed to confirm the time and to start the clock.
The 'DST' field appears only If 'DST Enable' is selected 'Yes', in 'Locale' (Section 6.1.2). If the 'box' contains a
cross (as shown) then Daylight Saving Time (DST) is not currently active. A 'tick' means that the time shown
has been advanced by an hour because DST is active.

6.1.2 Locale

Language
Date format
Time Zone
DST Enable
Start Time
Start On
Start Day
Page 48
Instrument.Clock
Date
Time
DST
Date Format
DST Enable
Start Month
Figure 40 Typical Instrument configuration menu (expanded to show all fields)
Select the language to be used for displays etc.
Select either DD/MM/YY, MM/DD/YY, or YY/MM/DD as the required format.
Select the required offset from GMT (UTC). This setting affects only the displayed time.
Archiving, recording etc. times remain in GMT.
Daylight Saving Time enable. Once the selection is enabled, the following (previously
hidden) fields appear, allowing the start and end dates for Daylight Saving Time (DST) to
be configured. DST affects only the displayed time. Archiving, recording etc. times remain
in GMT.
Appears only when 'DST Enable' (above) is set to 'Yes'. Use the up/down keys to scroll
to the required start time.
Select 'Last', 'First', 'Second', 'Third' or 'Fourth' as the required week. Used in conjunction
with the 'Start Day' and 'Start Month' entries following.
Select the day of the week on which DST is to commence.
FEC920: USER GUIDE
Figure 39 Clock menu
Instrument.Locale
Language English
DD/MM/YY
Time Zone GMT
Yes
Start Time 01:00
Start On Last
Start Day Sunday
March
End Time 02:00
End On Last
End day Sunday
End Month October
A5E45696052A Rev-AA
A
September 18