Go To View - Siemens FEC920 User Manual

5.3.3 Go to View

Operating the scroll key whilst the 'Go to view' item is highlighted, calls the Go to view submenu (Figure 12).
This allows the user to view channel alarms, system alarms, messages or to select a different display mode.
Vertical Bargraph Mode
Horizontal Bargraph Mode
Modbus Master display mode
Modbus Master display mode
EtherNet/IP display mode
Note 1: If an option is not fitted, its display mode does not appear in the list.
Note 2: Some display modes must be enabled in Instrument.View configuration (Section 6.1.3)
before they become available.
ALARM SUMMARY
For each active alarm, this page displays the channel identifier with alarm number (e.g. C1(2) = channel 1; alarm
2), the channel descriptor, the alarm threshold the current process value and an alarm type symbol.
To return to the top level menu, operate the Page key.
Note 1: The background color to the channel ID is the same as that chosen for the channel.
Note 2: A prefix 'C' in the channel ID means that this is a measuring channel; A prefix 'V' means that
this is a virtual channel (i.e. a totalizer, counter or maths channel.
Channel descriptor
Channel ID
(Alarm number)
A
September 18
Alarm Summary
System Alarms
Message Summary
Vertical Trend Mode
Horizontal Trend Mode
Numeric Mode
Alarm Panel Mode
Dual Loop
Figure 12 Go to view submenu
C1(2) Furnace 1 temp 1
C2(1) Furnace 1 temp 3
C3(1) Furnace 1 temp 2
C4(1) Furnace 2 temp 1
Figure 13 Alarm summary page with acknowledge confirmation display
FEC920: USER GUIDE
Alarm Summary
System Alarms
Message Summary
Vertical Trend
Horizontal Trend
Vertical Bargraph
Horizontal Bargraph
Numeric
Alarm Panel
Control
Control (Dual Loop)
Modbus Master
EtherNet/IP
Alarm Threshold
Alarm Summary
750.00 798.39
750.00 763.89
590.00 603.39
645.00 630.71
A5E45696052A Rev-AA
Channel current process value
Alarm Type indicator
Page key
Scroll key
Page 23