Table of Contents
Advertisement
Function
HDD Security Configuration
Secure Boot Menu
System Mode
Secure Boot
Vendor Keys
Secure Boot
Secure Boot Mode
Key Management
9.2.4.1. Remember the Password
It is highly recommended to keep a record of all passwords in a safe place. Forgotten passwords may lead to being
completely locked out of the system.
If the system cannot be booted because neither the User Password nor the Supervisor Password are known, refer to
the Chapter 3.1, for information about clearing the uEFI BIOS settings, or contact Kontron for further assistance.
The HDD security passwords cannot be cleared using the above method.
9.2.5. Boot Setup Menu
The Boot Setup menu lists the for boot device priority order, which is dynamically generated.
Table 53: Boot Priority Order
Function
Setup Prompt Timeout
Bootup NumLock State
Quite Boot
Boot Option #N
Fast Boot
SATA Support
VGA Support
USB Support
PS2 Devices Support
Network Stack Driver Support
Redirection Support
New Boot Option Policy
Hard Drive BBS Priorities
Description
Set HDD User password (only if HDD is attached)
Read only field
Display information about system mode
Read only field
Display information about secure boot active or not active
Read only field
Display information about vendor keys active or not active
Enable\Disable Secure Boot
Select Secure Boot Mode Standard or Custom
Secure Boot variables settings (for experienced users)
Description
Set number of seconds that the firmware will wait before initiating the
original default boot selection
Enable\Disable keyboard NumLock state
Enable\Disable Quite Boot
(N=1,2,3,...)Display the boot devices
Enable\Disable boot with initialization of a minimal set of devices required
to launch active boot option
Fast boot option to select All SATA or only last Boot HDD
Fast boot option to Select to install EFI driver or only install OpRom with
Legacy OS
Fast boot option to Disable, Partial or FULL initialization of USB devices
before OS
Fast boot option to Enable\Disable PS2 devices
Fast boot option to Enable\Disable Network Stack Driver
Enable\Disable Redirection
Controls placement of new detected UEFI boot option
Set the order of the legacy devices
www.kontron.com
mITX-BW – User Guide, Rev. 1.6
// 62
Advertisement
Table of Contents
