Page 1
DL-HD2100 Quick Install Guide This guide is for quick installati on only. For complete owners manual go to www.libav.com or use a QR reader to access the manual via QR code below. Scan QR Code with your Smart-phone or Tablet...
The 12 volt power supply is secured with a screw- on connector to prevent the power from being accidentally disconnected. The DL-HD2100 is sold only as a set. The individual transmitter and receiver are not compatible with other HDBaseT devices due to proprietary PoE circuitry.
Page 3
• HDMI input port for connecti ons to video sources Ethernet • RJ45 port for passing Ethernet to receiver / display locati on TOSLINK OUT • Digital audio return channel output port for routi ng multi -channel from DL-HD2100 receiver to audio amplifi er or mixer...
Page 4
Receiver FRONT PANEL DIAGNOSTIC LEDs; • POWER -Solid, the DL-HD2100 extender is receiving power from the power supply or from the remote extender via Category 6 cabling. • STATUS - Flashes once per second, the HDBaseT processor is running. • HDCP - Solid, HDCP signal is present in the HDMI stream. Flashes quickly, non-encrypted HDCP signal is present in the HDMI stream.
Page 5
8. Power on att ached audio/video devices. Passing IR Signals: The DL-HD2100 is capable of passing IR signals between 33 and 55 KHz. To prevent damage to any of the electronics, the extenders should be powered off while inserti ng or removing any IR components. Inserti ng an IR transmitt er into the IR IN port may damage the IR circuit for that extender.
Cabling Requirements To ensure proper performance of the DL-HD2100, it is recommended that you use solid core Category 6 F/UTP cabling at a minimum. Category 5e F/UTP may perform well but may not support power over HDBaseT reliably. When using shielded category cabling ALWAYS...
Technical Specifications Supported Audio and Video Video Compliance HDMI 2.0+, HDCP 2.2, ARC (Audio Return Channel) and CEC (Consumer Electronics Control) SMPTE: Up to 4096x2160@60Hz (4:4:4 chroma sub-sampling / 8 bit deep color) Input / Output Resolution Support VESA: Up to 1920x1200 Maximum Pixel Clock 594MHz Embedded Audio...
Page 8
Thank you for your purchase. For Technical Support please call our toll free number at 800-530-8998 or email us at supportlibav@libav.com www.libav.com Digitalinx is a brand of: 11675 Ridgeline Drive Colorado Springs, Colorado 80921 USA Phone: 719-260-0061 Fax: 719-260-0075 Toll-Free: 800-530-8998...