Making Basic Settings - Hirschmann RS20 series User Manual

3

Making basic settings

UNINTENTIONAL OPERATION IN DEVICE
Install and maintain a process that assigns a unique IP address to every
device in the network.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.
The IP parameters must be entered when the device is installed for the first
time. The device provides the following options for configuring IP addresses:
 Configuration via V.24 connection

Configuration using the HiDiscovery protocol

Configuration via BOOTP

Configuration via DHCP

Configuration via DHCP (Option 82)

Configuration using AutoConfiguration Adapter
Further information on the basic settings of the device can be found in the
"Basic Configuration" user manual on the CD/DVD.
Default settings

 IP address: The device looks for the IP address using DHCP
 Password for management:
Login: user; password: public (read only)
Login: admin; password: private (read and write)

V.24 data rate: 9,600 Baud

Ring redundancy: disabled

Ethernet ports: link status is not evaluated (signal contact)

Optical 100 Mbit/s ports: 100 Mbit/s, full duplex
All other ports: autonegotiation

Ring Manager disabled (DIP switch RM and Stand-by: ON)

Stand-by coupling disabled (DIP switch RM and stand-by: ON), Port 4
= control port, Port 3 = coupling port for redundant ring coupling
 Rapid Spanning Tree enabled
Installation RS20/22/30/32/40
Release 05 12/2015
WARNING
59