Hirschmann RS20 series User Manual page 47

RS22/RS32
RS20/RS30/RS40
To mount the device onto a horizontally mounted 35 mm DIN rail according
to DIN EN 60715, proceed as follows:
 Slide the upper snap-in guide of the device into the DIN rail.
 Pull down the locking gate using a screwdriver and press the lower part
of the device against the DIN rail.
 Snap in the device by releasing the locking gate.
Note: The overall shield of a connected shielded twisted pair cable is
connected to the ground connector on the front panel as a conductor.
Installation RS20/22/30/32/40
47
Release 05 12/2015