Installing An Sfp Transceiver (Optional); Adjust Dip Switch Settings - Hirschmann RS20 series User Manual

2.3

Installing an SFP transceiver (optional)

Use only Hirschmann SFP transceivers which are suitable for usage with the
device.
See "Accessories" on page 75.
Proceed as follows:
 Remove the protection cap from the SFP transceiver.
 Push the transceiver with the lock closed into the slot until it latches in.
2.4

Adjust DIP switch settings

The 2-pin DIP switch on the front panel of the device gives you the following
options:
RM
ON
Stand by
Figure 17: 2-pin DIP switch
Switch Switch
RM Stand-by
Position Position
OFF OFF
ON OFF
OFF ON
ON ON
Delivery state: both DIP switches "ON".
 Before starting operation of the device, check whether the default settings
of the DIP switch correspond to your requirements.
50
Ring Coupli Ring
redun ng manager
dancy switch
an an aus
on on on
on on off
Coupli Ring Contro
ng port l port
manag
er
aus 1 + 2
off 1 + 2
on 1 + 2 3
Installation RS20/22/30/32/40
Coupl Software
ing configuratio
port n
4
SW
configuration
has priority
over DIP
switch
configuration
Release 05 12/2015