Making Basic Settings - Hirschmann RS20 Series User Manual

2.3

Making basic settings

The IP parameters must be entered when the device is installed for the first
time. The device provides 6 options for configuring IP addresses:
Entry via V.24 connection
Entry using the HiDiscovery protocol
Configuration via BOOTP
Configuration via DHCP
Configuration via DHCP Option 82
Auto Configuration Adapter
Further information on the basic settings of the device can be found in the
"Basic Configuration" user manual on the CD ROM.
Default settings
IP address: The device looks for the IP address using DHCP
Password for management:
Login: user; password: public (read only)
Login: admin; password: private (read and write)
V.24 data rate: 9,600 Baud
Ring redundancy: disabled
Ethernet ports: link status is not evaluated (signal contact)
Optical 100 Mbit/s ports: 100 Mbit/s, full duplex
All other ports: autonegotiation
Ring Manager disabled (DIP switch RM and stand-by: ON)
Stand-by coupling disabled (DIP switch RM and stand-by: ON)
Port 4 = control port, port 3 = coupling port for red. Ring coupling
Rapid Spanning Tree enabled
USB interface
The USB socket has an interface for the local connection of an AutoCon-
figuration Adapter ACA 21-USB. It is used for saving/loading the configu-
ration data and diagnostic information, and for loading the software.
Figure Pin
1
2
3
1 2 3 4
4
Table 14: Pin assignment of the USB interface
46
Function
VCC (VBus)
- Data
+ Data
Ground (GND)
RS20/RS22/RS30/RS32/RS40
Release 12 07/09