Flowserve D30 Installation, Operation & Maintenance Manual page 25

The Man/Auto menu is used to change between manual and automatic modes.
The menu contents are shown in the figures on
the right and the various texts are described
below:
AUT, OK = MAN
Positioner in automatic mode
MAN, OK = AUT
Positioner in manual mode
In the MAN mode, the value of POS can be
changed using
increase/decrease the value in steps. The value
can also be changed in the same way as for the
other parameter values, as described on page
14
Other functions
C+ can be fully opened by pressing
then immediately OK simultaneously.
C- can be fully opened by pressing
simultaneously.
C+ and C- can be fully opened for blowing clean
by pressing
BASIC MENU
MAN/AUTO
. The push-buttons
and
and OK
and OK simultaneously.
D30 Digital Positioner
AUT, OK=MAN
POS= 12,3%
When changing between MAN and AUT
mode, the OK button must be pressed for 3
seconds.
25
FCD PMENIM0030-01-A5 – 05/18
MAN, OK=AUT
OK
POS= 12,3%