Table of Contents
Advertisement
3.2.4 Removal of Oven Linings
Remove screws in bottom of oven back panel. Ease panel bottom edge forward slightly and pull
down to release top location thus enabling panel to be withdrawn from oven.
Ease rear edge of RH panel slightly toward centre then pull it back to release front edge from
locating pins. Repeat for LH Panel. The base panel can now be lifted out.
3.2.5 Removal of RH Outer Side Panel
Undo oven control panel fixings and slide panel forward.
Undo burner chamber grille fixings and remove.
Undo side panel fixings along front edge.
Undo side panel fixings along rear edge.
Remove panel.
3.3
GAS CONTROLS
To service gas controls, proceed as follows:
3.3.1 To Remove Oven Multifunctional Control
Remove RH outer side panel (refer to Section 3.2.5). The unit may have to be temporarily pulled
forward to gain access.
Undo thermocouple securing nut and pilot supply pipe at rear and bottom of control.
Undo screw securing mains plug to control valve and remove plug.
Undo nuts on compression fittings on both inlet and outlet gas pipes.
Remove fixings securing control bracket to oven wall.
Remove fixings securing control bracket to valve.
Replace in reverse order.
When fitting a replacement control valve, transfer gas fittings and fixing bracket from old control to
new.
Set adjustment of replacement valve as detailed in Section 2.5.2.
3.3.2 To Remove Open Top Gas Taps (G2102 C only)
Remove hob control panel and hob. Refer to Sections 3.2.2 and 3.2.3.
Remove thermocouple connection from FFD section of tap.
Undo brass nut of compression fitting on gas supply pipe at gas tap rear.
Undo mounting screws and gently remove tap from supply manifold.
Replace in reverse order.
3.3.3 Re-greasing Open Top Gas Taps (G2102 C only)
Note - Plugs and bodies are machined in pairs and are therefore NOT INTERCHANGEABLE.
Always clean one tap at a time.
Remove hob control panel, refer to Section 3.2.2.
Remove fixings from tap body front. Withdraw spindle and niting arrangement to allow plug to be
eased out.
Clean gas tap plug with a soft rag and re-grease using an approved high temperature lubricant.
Take care not to over-grease as surplus may cause blockage in the gasways.
Replace parts in correct order and check for gas soundness.
Advertisement
Table of Contents
