Advertisement
SECTION 1 – INSTALLATION
WIDT
MODEL
H
mm
E1006 (Three
Solid
900
Hotplates)
E1016
General
900
Purpose
Oven
E1016/2
Two Tier
900
Oven
E1026 (Three
Solid
900
Hotplates)
also. A competent installer must be employed.
Where the appliance is to be positioned close to a wall, partition, kitchen furniture, decorative finish etc., of
combustible construction, there should be a clearance all round of 150mm.
In addition, this allows removal of side panels for servicing. The walls or partitions must be
combustible or clad with a similar material should the appliance be required to be positioned closer than
150mm.
1.3 ELECTRICITY SUPPLY
These appliances are suitable for AC supplies only. On the range, the standard terminal arrangement is for 3
phase / 4 wire connection but by linking the 3 line terminals, the unit can be connected to a single phase supply.
Suitable links are provided when single phase supply is specified at the time of ordering.
Note
When connecting to a single phase supply, the three line terminals must be connected together using the wire
links provided. It is important that the links and incoming supply cable are connected exactly as shown in the
following sketches.
General purpose ovens are single-phase operation only.
Each oven in a two tier unit has an independent connection point.
A suitably rated isolating switch with contact
wiring must be executed in accordance with the relevant regulations listed on the front cover of this manual.
UNLESS OTHERWISE STATED, PARTS WHICH HAVE BEEN PROTECTED BY THE
MANUFACTURER ARE NOT TO BE ADJUSTED BY THE INSTALLER
DEPT
HEIGH
H
T
mm
mm
850
890
850
890
850
1740
850
890
1.1
MODEL NUMBER, NETT WEIGHT and
WEIGH
DIMENSIONS
T
This manual refers to the following models –
kg
227
Note - Pot racks not included
1.2 SITING
150
Each unit must be fixed onto a firm, level, heat
resistant, non-combustible floor in a well lit position.
Units are best situated below a ventilating canopy to
300
remove cooking vapours etc.
Installation must be made in accordance with local
and/or national regulations applying at the time. Close
170
attention must be paid to fire prevention regulations
separation of at least 3mm in all poles, must be installed. The
non-
Advertisement
