Cisco ASR 9000 Series Configuration Manual page 74

Upgrading or Downgrading ROM Monitor Using the FPD PIE
DETAILED STEPS
Command or Action
Step 1
show hw-module fpd location all
Example:
RP/0/RSP0/CPU0:router# show hw-module
fpd location all
Step 2 admin
Example:
RP/0/RSP0/CPU0:router# admin
Step 3 show fpd package
Example:
RP/0/RSP0/CPU0:router(admin)# show fpd
package
Step 4 upgrade hw-module fpd rommon location [all
| node-id]
Example:
RP/0/RSP0/CPU0:router(admin)# upgrade
hw-module fpd rommon location 0/RSP1/CPU0
Step 5 exit
Example:
RP/0/RSP0/CPU0:router(admin)# exit
Step 6 If you are upgrading a single node on a router,
including a standby RSP, go to Step 9.
Step 7
If you are upgrading a router with redundant
RSPs, and want to perform a graceful reload, go
to Step 10.
Step 8
If you are upgrading a router with a single RSP,
or want to perform a cold restart on all nodes,
go to Step 11.
Cisco ASR 9000 Series Aggregation Services Router ROM Monitor Configuration Guide, Release 5.1.x
66
Upgrading and Downgrading ROM Monitor Firmware
Purpose
Displays the current FPD image versions for all cards installed in the
router. Use this command to determine if you must upgrade the ROM
monitor image on your cards.
Enters administration EXEC mode from EXEC mode.
(Optional) Displays which cards are supported with your current
Cisco IOS XR software release, which FPD or ROM monitor image you
need for each card, and what the minimum hardware requirements are
for the cards. If there are multiple FPD images for your card, use this
command to determine which FPD image to use if you want to upgrade
only a specific FPD type.
Upgrades the ROMMON B images on the specified card (node-id) or all
cards (all).
• Before you continue to reload the card, you should see a
Note
message indicating that the upgrade was completed
successfully.
• The use of force option when doing an fpd upgrade is not
recommended except under explicit direction from Cisco
Engineering or TAC.
Exits administration EXEC mode and returns to EXEC mode.
Continues to reload the node.
Continues to gracefully reload all nodes.
Continues to perform a cold restart of all nodes.
OL-30420-01