Cisco ASR 9000 Series Configuration Manual page 16

Resetting the Configuration Register and Reloading a RSP Card to ROM Monitor Mode
Verifying the Router State: Example
The following example shows the redundancy roles of both RSPs and shows that both are operating in
IOS XR RUN state:
RP/0/RSP0/CPU0:router#show redundancy
Wed Jun 30 21:35:23.656 UTC
Redundancy information for node 0/RSP0/CPU0:
==========================================
Node 0/RSP0/CPU0 is in ACTIVE role
Partner node (0/RSP1/CPU0) is in STANDBY role
Standby node in 0/RSP1/CPU0 is ready
Standby node in 0/RSP1/CPU0 is NSR-ready
Reload and boot info
----------------------
A9K-RSP-8G reloaded Tue Jun 29 18:56:15 2010: 1 day, 2 hours, 39 minutes ago
Active node booted Tue Jun 29 18:56:15 2010: 1 day, 2 hours, 39 minutes ago
Standby node boot Tue Jun 29 18:55:54 2010: 1 day, 2 hours, 39 minutes ago
Standby node last went not ready Tue Jun 29 18:58:52 2010: 1 day, 2 hours, 36
minutes ago
Standby node last went ready Tue Jun 29 18:59:52 2010: 1 day, 2 hours, 35 minutes
ago
There have been 0 switch-overs since reload
Active node reload "Cause: Node reload is required by install operation"
Standby node reload "Cause: pID node reload is required by install operation"
RP/0/RSP0/CPU0:router#show redundancy summary
Wed Jun 30 21:35:32.259 UTC
Active Node
-----------
0/RSP0/CPU0
RP/0/RSP0/CPU0:router#show platform
Wed Jun 30 21:35:35.944 UTC
Node
-----------------------------------------------------------------------------
0/RSP0/CPU0
0/RSP1/CPU0
0/1/CPU0
0/5/CPU0
0/6/CPU0
Placing the RSP Cards in ROM Monitor Mode: Example
The following example shows how to place the RSP in the ROM Monitor mode:
RP/0/RSP0/CPU0:router#
RP/0/RSP0/CPU0:router(admin)#
Set to rom-monitor mode for all mgmt nodes:
RP/0/RSP0/CPU0:router(admin)#config-register boot-mode rom-monitor location all
Successfully set config-register to RP/0/RSP0/CPU0:router
Successfully set config-register to RP/0/RSP0/CPU0:router
Cisco ASR 9000 Series Aggregation Services Router ROM Monitor Configuration Guide, Release 5.1.x
8
Standby Node
------------
0/RSP1/CPU0 (Ready, NSR: Ready)
Type
A9K-RSP-8G(Active)
A9K-RSP-8G(Standby)
A9K-8T-E
A9K-40GE-B
A9K-2T20GE-E
admin
config-register boot-mode rom-monitor location all
State Config State
IOS XR RUN PWR,NSHUT,MON
IOS XR RUN PWR,NSHUT,MON
IOS XR RUN PWR,NSHUT,MON
IOS XR RUN PWR,NSHUT,MON
IOS XR RUN PWR,NSHUT,MON
ROM Monitor Overview
OL-30420-01