What To Do Next; Additional References; Related Documents - Cisco ASR 9000 Series Configuration Manual

What to Do Next

What to Do Next
After the system is up and in EXEC mode, you can execute the full range of CLI commands from the RSP
card.
Note If there was no previous router configuration, you must enter a root-system username and password when
the boot process is complete.
After reinstalling the software, you might want to verify interfaces, install additional packages or perform
other configuration tasks:
• For instructions on how to verify that the interfaces are up and properly configured, see Verifying the
• Install additional software from the PIE files, as necessary. For more information, see the Upgrading

Additional References

The following sections provide references related to the ROM Monitor.

Related Documents

Related Topic
Contact a Cisco representative
Save current router configuration
Verify that interfaces are up and properly
configured
Install or upgrade software packages from
PIE files
Redundancy slot pairs
Cisco ASR 9000 Series Aggregation Services Router ROM Monitor Configuration Guide, Release 5.1.x
36
System Interfaces in the
and Managing Cisco IOS XR Software module of Cisco ASR 9000 Series Aggregation Services Router
System Management Configuration Guide.
Document Title
"Obtaining Additional Publications and Information" in
What's New in Cisco Product Documentation located at:
/www.cisco.com/en/US/docs/general/whatsnew/
whatsnew.html
Upgrading and Managing Cisco IOS XR Software module of
Cisco ASR 9000 Series Aggregation Services Router Getting
Started Guide
Managing the Router Hardware module of
Cisco ASR 9000 Series Aggregation Services Router Getting
Started Guide
Router Recovery with ROM Monitor
http:/
OL-30420-01