Cisco ASR 9000 Series Configuration Manual page 22

Displaying Environment Variable Settings
Environmental variable
BOOT_DEV_SEQ_OPER=drive:
BOOT_DEV_SEQ_CONF=drive:
AUX_AUTHEN_LEVEL=number
IOX_ADMIN_CONFIG_FILE= drive:path/file
IOX_CONFIG_FILE=drive:path/file
IOX_CONFIG_MEDIUM=drive:path
MIRROR_ENABLE=value
Displaying Environment Variable Settings
To display the current environment variable settings, enter the set command at the ROM Monitor mode prompt
:
rommon B1>
PS1=RO RSP P4D-17 ! >
IP_ADDRESS=172.29.52.137
DEFAULT_GATEWAY=172.29.52.1
IP_SUBNET_MASK=255.255.255.0
TFTP_SERVER=172.23.16.81
IOX_ADMIN_CONFIG_FILE=
TFTP_MGMT_INTF=0
Cisco ASR 9000 Series Aggregation Services Router ROM Monitor Configuration Guide, Release 5.1.x
14
set
ROM Monitor Overview
Description
Specifies the sequence of local
storage devices in which the
disk-boot operation occurs. (For
example, the disk0:;disk1: sequence
indicates to boot from disk0: device
initially and if failure occurs, boot
from the disk1: device.
Indicates the configured primary
and secondary devices (disk0: and
disk1:) for disk mirroring. This
variable is usually set by
Cisco IOS XR software.
Bypasses ksh authentication. A
reboot is required only on the card
that has to bypass authentication.
Permanently changes the location
of the default administration
configuration file.
Permanently changes the location
of the router configuration file.
Permanently changes the default
location where configuration files
are saved.
Sets to Y in Cisco IOS XR software
to indicate disk mirroring is
enabled. When it is set to N, it
indicates disk mirroring is disabled.
OL-30420-01