Specifying a Permanent SDR Configuration File with the IOX_CONFIG_FILE= Variable
Command or Action
Example:
rommon B3> set
Step 8
IOX_CONFIG_FILE=drive:path/file
Example:
rommon B1>
IOX_CONFIG_FILE
admingold.conf
Step 9
sync
Example:
rommon B1> sync
Step 10
boot
Example:
rommon B1> boot
Step 11
confreg
Example:
rommon B2 >
Configuration Summary
(Virtual Configuration Register: 0x1920)
enabled are:
console baud: 9600
boot: the ROM Monitor
do you wish to change the configuration? y/n
[n]:
y
enable
"diagnostic mode"? y/n
change console baud rate? y/n
change the boot characteristics? y/n
enter boot type:
0 = ROM Monitor
2 = MBI Validation Boot Mode
[0]:
2
Step 12
Enter boot type as 2.
Example:
enter boot type:
0 = ROM Monitor
2 = MBI Validation Boot Mode
[0]:
2
Cisco ASR 9000 Series Aggregation Services Router ROM Monitor Configuration Guide, Release 5.1.x
52
=/disk2:/cfgarchives/
confreg
[n]:
[n]:
Purpose
The filename is set in the IOX_CONFIG_FILE
Note
variable.
Sets the IOX_CONFIG_FILE variable to specify the absolute
path of a different SDR configuration file.
The IOX_CONFIG_FILE variable is overridden by
Note
the boot command when it is entered with the -a
option.
Saves the changes.
Boots the router.
Sets the configuration register of the standby RSP to exec
mode. You can also change the console baud rate, boot
characteristics, boot type configuration settings and enable
diagnostic mode at the ROM Monitor mode.
n
n
[n]:
y
Sets the boot type as 2 for the standy RSP to enable MBI
validation mode or the EXEC mode during the next system
boot.
Managing Configuration Files in ROM Monitor
OL-30420-01