Cisco ASR 9000 Series Configuration Manual page 59

Managing Configuration Files in ROM Monitor
Command or Action
enabled are:
console baud: 9600
boot: the ROM Monitor
do you wish to change the configuration? y/n
[n]: y
enable "diagnostic mode"? y/n
change console baud rate? y/n
change the boot characteristics? y/n
enter boot type:
0 = ROM Monitor
2 = MBI Validation Boot Mode
[0]: 0
Step 3 Enter the boot type as 0.
Example:
enter boot type:
0 = ROM Monitor
2 = MBI Validation Boot Mode
[0]: 0
Step 4
reset
Example:
rommon B3> reset
Step 5
confreg
Example:
rommon B1 >
Configuration Summary
(Virtual Configuration Register: 0x1920)
enabled are:
console baud: 9600
boot: the ROM Monitor
do you wish to change the configuration? y/n
[n]: y
enable "diagnostic mode"? y/n
change console baud rate? y/n
change the boot characteristics? y/n
enter boot type:
0 = ROM Monitor
2 = MBI Validation Boot Mode
[0]: 2
Step 6 Enter the boot type as 2.
Example:
enter boot type:
0 = ROM Monitor
2 = MBI Validation Boot Mode
[0]: 2
Step 7
set
OL-30420-01
Specifying a Permanent SDR Configuration File with the IOX_CONFIG_FILE= Variable
[n]:
[n]:
confreg
[n]:
[n]:
Cisco ASR 9000 Series Aggregation Services Router ROM Monitor Configuration Guide, Release 5.1.x
Purpose
The configuration register is not an environment
Note
variable like TURBOBOOT. Do not enter an equal
sign when entering the confreg command.
n
n
[n]: y
Sets the boot type as 0 to enable ROM Monitor mode during
the next system boot.
Makes the configuration register settings for the standby RSP
card effective.
Sets the active RSP configuration register to EXEC mode.
You can also change the console baud rate, boot
characteristics, boot type configuration settings and enable
diagnostic mode at the ROM Monitor mode.
n
n
[n]: y
Sets the boot type as 2 for the active RSP to enable MBI
validation mode or the EXEC mode during the next system
boot.
Displays the current environment variable settings.
51