Cisco ASR 9000 Series Configuration Manual page 53

Managing Configuration Files in ROM Monitor
Command or Action
Step 4
reset
Example:
rommon B3> reset
Step 5 confreg
Example:
rommon B1 >
Configuration Summary
(Virtual Configuration Register: 0x1920)
enabled are:
console baud: 9600
boot: the ROM Monitor
do you wish to change the configuration? y/n
[n]: y
enable "diagnostic mode"? y/n
change console baud rate? y/n
change the boot characteristics? y/n
enter boot type:
0 = ROM Monitor
2 = MBI Validation Boot Mode
[0]: 2
Step 6 Enter the boot type as 2.
Example:
enter boot type:
0 = ROM Monitor
2 = MBI Validation Boot Mode
[0]: 2
Step 7 set
Example:
rommon B2> set
Step 8
IOX_ADMIN_CONFIG_FILE=drive:path/file
Example:
rommon B3>
IOX_ADMIN_CONFIG_FILE=/disk2:/cfgarchives/
admingold.conf
Step 9
sync
Example:
rommon B4> sync
OL-30420-01
Specifying a Permanent Alternative Administrative Configuration File with the IOX_ADMIN_CONFIG_FILE= Variable
confreg
[n]:
[n]:
Cisco ASR 9000 Series Aggregation Services Router ROM Monitor Configuration Guide, Release 5.1.x
Purpose
Makes the configuration register settings for the standby RSP
card effective.
Sets the active RSP configuration register to EXEC mode.
You can also change the console baud rate, boot
characteristics, boot type configuration settings and enable
diagnostic mode at the ROM Monitor mode.
n
n
[n]: y
Sets the boot type as 2 for the active RSP to enable MBI
validation mode or the EXEC mode during the next system
boot.
Displays the current environment variable settings.
The filename is set in the
Note
IOX_ADMIN_CONFIG_FILE variable.
Sets the IOX_ADMIN_CONFIG_FILE variable to specify
the absolute path of a different admin configuration file.
The IOX_ADMIN_CONFIG_FILE variable is
Note
overridden by the boot command when it is entered
with the -o option.
Saves the changes.
45