Cisco ASR 9000 Series Configuration Manual page 49

Managing Configuration Files in ROM Monitor
SUMMARY STEPS
1. Place the RSP and the standby RSP in ROM Monitor mode.
2. confreg
3. Enter boot type as 0.
4. reset
5. confreg
6. Enter boot type as 2.
7. set
8. boot image –o config-file-path
9. confreg
10. Enter boot type as 2.
11. reset
DETAILED STEPS
Command or Action
Step 1 Place the RSP and the standby RSP in ROM Monitor
mode.
Step 2 confreg
Example:
rommon B1 > confreg
Configuration Summary
(Virtual Configuration Register: 0x1920)
enabled are:
console baud: 9600
boot: the ROM Monitor
do you wish to change the configuration? y/n [n]:
y
enable "diagnostic mode"? y/n [n]: n
change console baud rate? y/n [n]: n
change the boot characteristics? y/n [n]: y
enter boot type:
0 = ROM Monitor
2 = MBI Validation Boot Mode
[0]: 0
Step 3 Enter boot type as 0.
Example:
enter boot type:
0 = ROM Monitor
2 = MBI Validation Boot Mode [0]: 0
Step 4 reset
Example:
rommon B2> reset
OL-30420-01
Specifying a Temporary Alternative Administrative Configuration with the -o Boot Option
Cisco ASR 9000 Series Aggregation Services Router ROM Monitor Configuration Guide, Release 5.1.x
Purpose
Sets the configuration register of the standby RSP to ROM
Monitor mode so that the standby RSP does not take control.
Enter the confreg command at the ROM Monitor mode prompt
to set the configuration register to ROM Monitor mode. You
can also change the console baud rate, boot characteristics,
boot type configuration settings, and enable diagnostic mode
at the ROM Monitor mode.
The configuration register is not an environment
Note
variable like TURBOBOOT. Do not enter an equal
sign when entering the confreg command.
Sets the boot type as 0 to enable ROM Monitor mode during
the next system boot.
Makes the configuration register settings for the standby RSP
card effective.
41