Cisco ASR 9000 Series Configuration Manual page 57

Managing Configuration Files in ROM Monitor
Command or Action
Example:
rommon B2> set
Step 8
boot image –a config-file-path
Example:
boot
rommon B3>
tftp://223.255.254.254/images/comp-asr9k-mini.vm
-a
/disk1:/cfgarchives/SDRgold.conf
Step 9 confreg
Example:
confreg
rommon B3>
Configuration Summary
(Virtual Configuration Register: 0x1920)
enabled are:
console baud: 9600
boot: the ROM Monitor
do you wish to change the configuration? y/n
[n]: y
enable "diagnostic mode"? y/n
change console baud rate? y/n
change the boot characteristics? y/n
enter boot type:
0 = ROM Monitor
2 = MBI Validation Boot Mode
[0]: 2
Step 10
Enter boot type as 2.
Example:
enter boot type:
0 = ROM Monitor
2 = MBI Validation Boot Mode
[0]: 2
Step 11 reset
Example:
rommon B5 > reset
OL-30420-01
[n]: n
[n]: n
[n]:
Cisco ASR 9000 Series Aggregation Services Router ROM Monitor Configuration Guide, Release 5.1.x
Specifying a Temporary SDR Configuration File with the -a Boot Option
Purpose
The filename is set in the BOOT
Note
variable.
Boots the router. Replace image with the filename listed in
the boot variable, and replace config-file-path with the path
and filename for the configuration file.
The pathname should be a valid UNIX pathname (a slash [/]
must be included after the device: "disk1:/").
Sets the configuration register of the standby RSP to EXEC
mode. You can also change the console baud rate, boot
characteristics, boot type configuration settings, and enable
diagnostic mode at the ROM Monitor mode.
y
Sets the boot type as 2 for standy RSP to enable MBI
validation mode or the EXEC mode during the next system
boot.
Resets the standby RSP card so that the new setting can take
effect and the standby RSP card becomes operational.
49