Basic Operation; Remote Controller - Adam Equipment IHS Series Manual

3.4 BASIC OPERATIONS
Power on and off- Press [On/Off] key to turn on the scale. Then the display on the scale will
show [88888]. Press again to turn off the scale.
Zero the scale-Depress the [Zero] to re-zero the reading.
Change division- you can use the [Change/lb/kg] key to change division.
Lb/kg- you use this to select either lb or kg weighing units
Hold -when required, such as when the reading is not stable or you cannot pause to record a
reading, you can use the [Hold] key to lock the reading, so that you can read it easily later,
after you finish reading, press [Hold] again to return to normal weighing mode.
Note: The [Hold] key has no affect if the Hold parameter has been disabled. See section 5.1
Overload Warning-: please do not add any item that exceeds the maximum capacity of the scale.
When the buzzer is sounded and the display shows"-----", remove the item to avoid damage to the
load cell and scale.

3.5 REMOTE CONTROLLER

© Adam Equipment 2017
A: Determine increments in which the weight display
B: Hold the settled values
C: Zero the scale
D: Backlight (only used on scales with LCD display)
10