Calibration - Adam Equipment LHS Series Manual

4.0 CALIBRATION
 Press the [Zero] key and power up the scale using the on/off button.
 Release the [Zero] key and the display will show "SPAN". Make sure the hook is
empty unless you intend to use any chains, slings etc to hold the calibration mass.
Add any items such as these to the hook before continuing.
 Press the [Zero] button and the display will show "SET" then "00000" when the
reading at zero is stable. This completes the zero calibration.
 Following zero calibration the value of the mass being used to calibrate the scale
should be entered. Use the [Hold] button to increment the right hand digit, and the
[Unit] button to move this digit to the left. Proceed by entering a number for the next
digit if required, until the value of your chosen calibration weight is displayed
correctly.
 Load this mass onto the hook and when the scale is stable press the [Zero] key. The
display shows 'HOLD'.
 After a few seconds, the calibration is complete and the scale returns to normal
weighing showing the value of the calibration mass as used.
** To calibrate in Lbs make sure that the scale is Lbs mode before commencing, to calibrate
in Kg make sure the scale is in Kg mode before commencing.
© Adam Equipment Company 2017
9