GRAUPNER mz-10 HoTT Manual page 39

S1042_sh_V1
After releasing the button the status LED and the acoustic signal
should indicate the actual transmitter (power on) "control mode"
status.
3. Check the settings by switching the transmitter off.
If analogue servos can not be moved by hand, repeat the proce-
dure.
Standard mode
In this mode in case of interference only the throttle servo (channel
1) moves to the position preset for this event, all other channels
remain in "hold".
Programming step-by-step
1. Move the throttle stick and its trim to the desired position.
2. Press the MODE button to the left of the LED field for three to
four seconds to store these items in the receiver.
After releasing the button the status LED and the acoustic signal
should indicate the actual transmitter (power on) "control mode"
status.
3. Release the throttle stick.
4. Check the settings by switching the transmitter off.
If the throttle servo does not move to the desired position, repeat
the procedure.
39 / 48