GRAUPNER mz-10 HoTT Manual page 38

38 / 48
Programming step-by-step
1. Select the desired mode
2. Use the controls on the transmitter to move the servos of the
model to the desired positions and hold them.
3. Press the MODE button to the left of the LED field for three to
four seconds to store these items in the receiver.
After releasing the button the status LED and the acoustic signal
should indicate the actual transmitter (power on) "control mode"
status.
4. Release the control elements.
5. Check the settings by switching the transmitter off.
If the servos do not move to the desired positions, repeat the
procedure.
Mode "Hold"
In case of transmission interruptions, all servos programmed to
"hold" remain at their position which was last identified to be correct
until a new, correct control signal is received by the receiver.
Programming step-by-step
1. Select the desired mode
2. Press the MODE button for three to four seconds.
After releasing the button the status LED and the acoustic signal
should indicate the actual transmitter (power on) "control mode"
status.
3. Check the settings by switching the transmitter off.
If the servos do not remain in the most recently reached posi-
tions, repeat the procedure.
Fail-Safe "OFF"
With the "OFF" setting, over the course of a malfunction, the receiver
stops transmitting control pulses for the relevant servo output The
receiver switches off of the pulse line in a manner of speaking.
Attention
Analogue servos and many digital servos no longer experience resis-
tance to the ongoing control pressure after control pulses stop and
are moved out of their position at higher or lower speed.
Programming step-by-step
1. Select the desired mode
2. Press the MODE button for three to four seconds.
S1042_sh_V1