Binding; Binding Several Receivers - GRAUPNER mz-10 HoTT Manual

binding

Binding several receivers

24 / 48
The receiver GR-12L in the set No. S1042 is already factory-bound to
the transmitter. If you want to bind another receiver, proceed as
described below, Binding step-by-step.
When binding, make sure that the transmitter antenna is always far
enough away (1 to 2 meters) from the receiver antenna(s).
Note
The mz-10 HoTT can only be bound in "NORMAL" use mode. Make
sure, before starting the "binding" process, that the transmitter is
in this use mode.
Binding step by step
1. Switch the transmitter on and connect the power supply to the
receiver.
The BIND LED of the transmitter remains dark and the red LED of
the receiver GR-12L lights up constantly. There is no contact with
the transmitter.
2. Press and hold the receiver's SET button for approx. 3 seconds to
turn the receiver GR-12L to bind it to the bind mode.
The red LED turns off.
3. Push the MODE button on the already switched on the mz-10
HoTT transmitter.
If the red LED of the GR-12L receiver goes out within about 10
seconds and the green LED is illuminated, the binding process
has been completed successfully. Your transmitter/receiver com-
bination is ready for operation.
If the red LED of the receiver lights constantly and the yellow
BIND LED of the transmitter remains dark, the binding operation
failed. Change the positions of the antenna and try the entire
procedure again.
4. After the binding perform a range test (see section "Range test").
If necessary it is also possible to bind more than one receiver. First
bind each receiver individually as described earlier.
In next use the transmitter will however set a telemetry connection
only with the last bound receiver.
S1042_sh_V1