The plug-in connectors on the rear panel of the FC-5000 Flow Display are:
• TB1: Power
• USB Type-A Receptacle: Host (external memory flash drive)
• USB mini-B Receptacle: Device
• TB5: Flow Meter/Sensor input, either
◊ Single Input (PULSE IN)
◊ Dual Inputs (2 PULSE IN)
• TB7: Two scaled outputs, either:
◊ Analog (scaled output, option "A")
◊ Frequency (scaled output, option "F")
• TB8: Communications
• TB2: Digital inputs and outputs
• TB3: Form C Relay
• TB4: Form C Relay
• TB6: Not active
THE FC-5000 IS MICROPROCESSOR CONTROLLED. IT IS VERY IMPORTANT THAT THE
POWER SUPPLY BE FREE OF ELECTRICAL NOISE. AVOID USING POWER LINES THAT
FEED HEAVY LOAD ELECTRICAL DEVICES SUCH AS PUMPS AND MOTORS.
June 2018
Figure 6: Two sensor inputs, frequency output
Figure 7: Two sensor inputs, analog output
CTL-UM-02765-EN-01
Installing the Flow Display
Page 13