Advantech Adam 4000 Series User Manual page 108

Data acquisition modules
Hide thumbs Also See for Adam 4000 Series:
Table of Contents

Advertisement

Table 4.6: ADAM-4016 Command Table
#AA
$AA0
$AA1
#**
$AA4
$AA6
$AA7
$AAS
$AAE
$AAA
$AAB
@AADI
@AADO(data)
@AAEAT
@AAHI(data)
@AALO(data)
@AADA
@AACA
@AARH
@AARL
ADAM-4000 Series User Manual
Return the input value from the speci-
Read Analog Input
fied analog input module in the cur-
rently configured data format
Calibrates an analog input module to
Span Calibration
correct for gain errors
Calibrates an analog input module to
Offset Calibration
correct for offset errors
Orders all analog input modules to
Synchronized
sample their input values and store
Sampling
them in special registers
Returns the value that was stored in
Read Synchronized
the specified module's register after
Data
the #** command
Returns either last value sent to spec-
Get Excitation
ified module by $AA7 command, or
Voltage Output Value
start-up output voltage
Excitation Voltage
Direct output excitation voltage data
Output
to a specified module
Stores a default value in a specified
Start-up Voltage Out-
module. The output value will take
put Configuration
effect upon startup
Trims specified module a number of
Trim Calibration
units up or down
Tells the module to store parameters
Zero Calibration
for zero calibration
Tells the module to store parameters
Span Calibration
for span calibration
The addressed module returns the
Read Digital I/O and
state of its digital input channel, its
Alarm Status
two digital output channels and the
status of its alarm
Set the values of the module's two
Set Digital Output
digital outputs (ON or OFF)
Enables the alarm in either Momen-
Enable Alarm
tary or Latching mode
Set High Alarm
Downloads the High alarm limit value 5-56
Set Low Alarm
Downloads the Low alarm limit value 5-57
Disable Alarm
Disables all alarm functions
Clear Latch Alarm
The latch alarm is reset
The addressed analog input module
Read High Alarm
is asked to return its high alarm value
The addressed analog input module
Read Low Alarm
is asked to return its low alarm value
94
5-14
5-19
5-20
5-21
5-22
5-65
5-66
5-67
5-69
5-70
5-71
5-50
5-52
5-54
5-58
5-59
5-60
5-61

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents