Intermec TRAKKER Antares 2420 User Manual page 273

Configuration Commands Listed by Category (continued)
RF Network Communications
Acknowledgement Delay Lower Limit, 9-7
Acknowledgement Delay Upper Limit, 9-9
Controller Connect Check Receive Timer, 9-40
Controller Connect Check Send Timer, 9-41
Controller IP Address, 9-43
Default Router, 9-47
Dynamic Host Configuration Protocol (DHCP), 9-54
Host IP Address, 9-62
Maximum Retries, 9-69
Network Activate, 9-76
Network Loopback, 9-77
Network Port, 9-78
RF Domain, 9-90
RF Inactivity Timeout, 9-91
RF Roaming Flag, 9-92
RF Security Identification (ID), 9-93
RF Transmit Mode, 9-94
RF Wakeup On Broadcast, 9-95
Subnet Mask, 9-107
TCP/IP Maximum Retries, 9-109
TCP/IP Maximum Transmit Timeout, 9-110
Terminal IP Address, 9-112
C o d e 39
Nugget
Configuration Command Reference
Serial Network Communications
Baud Rate, 9-13
Configuration Commands Via Serial Port, 9-38
Data Bits, 9-45
End of Message (EOM), 9-55
Flow Control, 9-58
Handshake, 9-61
LRC (Longitudinal Redundancy Check), 9-68
Modem Dial Sequence, 9-71
Modem Initialization Sequence, 9-73
Parity, 9-80
Poll (Polling), 9-83
Serial Port Protocol, 9-102
Start of Message (SOM), 9-104
Stop Bits, 9-106
Timeout Delay, 9-116
9
9-5