wtw inoLab pH/ION Level 2 Operating Manual page 46

Operation
Outputting to
printer/interface
130
You can perform the following activities:
Display further parameters of the data record
(I.D. no., date, time, memory location)
Advance one data record (memory location)
Go back one data record (memory location)
Note
If you want to find a specific parameter (e.g. date), proceed
as follows:
1 Select the parameter (e.g. date) by pressing
u
2 Press or
pears on the display. After approx. 2 s, the tempera-
ture of the displayed measured value appears.
r
1 Press the
on the display.
g
2 Press the
Sto CAL appears on the display. The calibration pro-
tocol is transmitted to the printer/interface.
Following the calibration protocol, the complete con-
tents of the storage is transmitted to the printer/inter-
face.
Note
You can the cancel the transmission by pressing
d
repeatedly until the required date ap-
key repeatedly until Sto SEr appears
key.
g
Press
u
Press
d
Press
g
.
m g
or .