wtw inoLab pH/ION Level 2 Operating Manual page 42

Operation
StoFull StoFull
StoFull StoFull
message
126
2 Confirm with
The display changes to the input of the I.D. number.
3 Enter the required I.D. number (1 ... 999) by pressing
u d
.
Note
Up to this point, you can cancel with
out storing.
4 Confirm with
data storage.
The instrument changes to the measuring mode.
This message appears if all 800 memory locations are full.
You have the following options:
Store the current measured value.
The oldest measured value (memory
location 1) is overwritten by this
Return to the measuring mode without
storing
Output the data storage
Delete the data storage
g
.
g
. The measured value is stored in the
m
the procedure with-
g
Press
Press any key
See section
4.7.3
See section
4.7.4