Table of Contents
Advertisement
4.2 Servicing and maintenance
4.2.1 Cleaning of the Industrial PC
Disconnect power supply
Switch off the Industrial PC and all connected devices, and disconnect the Industrial
PC from the power supply.
DANGER
The device can be cleaned with a soft, damp cleaning cloth. Do not use any aggressive cleaning
materials, thinners, scouring material or hard objects that could cause scratches.
4.2.2 Maintenance
The Industrial PC is maintenance-free.
4.2.3 Replacing the Battery on the Motherboard
A used battery on the motherboard has to be replaced. See also chapter
Danger of Explosion!
The battery is a CR2032 type (nominal voltage: 3.0 V) from e.g. Panasonic or Sanyo.
Replace battery only with the identical type or an alternative type recommended by the
WARNING
manufacturer. Notice correct polarity!
Handling of Lithium Batteries
Lithium Batteries should not be recharged, exposed to fire, opened and they should be
WARNING
protected against sunlight and moisture.
The used battery must be disposed of in accordance with national electronics scrap regulations.
4.3 Emergency procedures
In case of fire, the Industrial PC should be extinguished with powder or nitrogen.
4.4 Shutting down
4.4.1 Disposal
Observe national electronics scrap regulations
Observe the national electronics scrap regulations when disposing of the device.
Note
In order to dispose of the device, it must be removed and fully dismantled:
•
Housing components (polycarbonate, polyamide (PA6.6)) are suitable for plastic recycling
•
Metal parts can be sent for metal recycling
•
Electronic parts such as disk drives and circuit boards must be disposed of in accordance with
national electronics scrap regulations.
C6670-0010
Operating Instructions
Access to the
battery.
21
Advertisement
Table of Contents
