Factory-Set Default Parameters - Instrutech The Hornet IGM402 User Manual

Instruction Manual

Factory-Set Default Parameters

5.7
The following is a summary of all factory-set default values in the IGM402 Top Level Program Menu.
SETUP DISP
- SET CONTRAST [Factory default = 10]
- SHOW DATA [Factory default = SHOW ALL LG]
- DISPLAY INT [Factory default = 3 SECONDS]
- FLIP SCREEN [Factory default = NORMAL]
- SCREEN SAVER [Factory default = ON]
SETUP UNIT
- UNITS [Factory default = TORR]
- DEFAULTS [Factory default = MENU TO EXIT]
- CLR IG ERROR [Factory default = OFF]
- 100UA TRN ON [Factory default = 5.00E-02 TORR]
- IG CNTL [Factory default = DIGI/RS485, (Factory default is DIGI or Digital Input, see requirement for
switching from DIGI to RS485 mode at the
the Top Level Program Menu shown here will be modified; See
modified Top-Level Program Menu choices when IG CNTL is set for FRONT PANEL.
SETUP IG
- DEGAS TIME [Factory default = 2]
- SENSITIVITY [Factory default = Actual Sensor sensitivity (see label on gauge)]
- FILAMENT NUM [Factory default = FILAMENT 1]
- RLY I LO TRP [Factory default = 1.00E-06 TORR]
- RLY I HI TRP [Factory default = 5.00E-06 TORR]
- RELAY I TEST [Factory default = OFF]
- ANALOG MODE [Factory default = IG ONLY]
- FIL USAGE [Factory default = Displays to-date filament usage]
SETUP CGS
- RLY A LO TRP [Factory default = 1.00E-1 TORR]
- RLY A HI TRP [Factory default = 2.00E-1 TORR]
- RELAY A TEST [Factory default = OFF]
- RLY B LO TRP [Factory default = 1.00E-1 TORR]
- RLY B HI TRP [Factory default = 2.00E-1 TORR]
- RELAY B TEST [Factory default = OFF]
- ASSIGN RLY A [Factory default = CG1]
- ASSIGN RLY B [Factory default = CG2]
InstruTech
DIGI/RS485 section, below)] If IG CNTL is set to FRONT PANEL,
section 5.8.2., -FRONT
IGM402 Hornet
PANEL, for the
Page 22