Instrutech The Hornet IGM402 User Manual page 75

Instruction Manual
Depending on the age of your device the following new additional commands showing the filament condition may not be
available with your unit. If your device does not respond to the following commands it does have not have these latest
additions. The last four parameters shown below provide the same type of information when the setup and programming
display screen is set to the RESEARCH mode.
COMMAND BRIEF DESCRIPTION
READ PRESSURE Read pressure unit
UNIT
SET PRESSURE Set Pressure unit for display
UNIT and RD response
READ IG ION Read the current IG ion
CURRENT current in amps
READ IG EMISSION Read the actual IG emission
CURRENT current being measured by
the gauge in amps
READ IG FILAMENT Read the current IG
VOLTAGE filament voltage in volts
READ IG FILAMENT Read the current IG
CURRENT filament current in amps
InstruTech
COMMAND SYNTAX RESPONSE
#xxRU<CR> *xx_TORR____<CR>
(eg: #01RU<CR>) *xx_MBAR____<CR>
*xx_PASCAL__<CR>
#xxSUx<CR> *xx_PROGM_OK<CR>
(eg: #01SUT<CR>) T = Torr, M = mBar, P = Pascal
#xxRDIGC<CR> *xx_y.yyEzyy<CR>
(eg: #01RDIGC<CR>) (eg: *01_1.53E-06<CR>)
When sensor is off: indicate offset
voltage.
#xxRDIGE<CR> *xx_y.yyEzyy<CR>
(eg: #01RDIGE<CR>) (eg: *01_1.00E-04<CR>)
When sensor is off: 0.00E-00
#xxRDIGV<CR> *xx_y.yyEzyy<CR>
(eg: #01RDIGVCR>) (eg: *01_1.20E-00<CR>)
When sensor is off: 0.00E-00
#xxRDIGA<CR> *xx_y.yyEzyy<CR>
(eg: #01RDIGACR>) (eg: *01_2.20E-00<CR>)
When sensor is off: 0.00E-00
IGM402 Hornet
Page 73