Set Room Temperature Sensor Location - Lennox V0STAT51P-2 Installation And Operation Instructions Manual

Set Room Temperature Sensor Location

Determine if the room temperature will be sensed using the controller sensor or the indoor unit
sensor. This is the sensor the controller will use to decide when the setpoint has been satisfied.
1. Tap the Menu button on the Home screen.
2. Tap the Service button and then enter your password.
3. Tap the Room Temperature Sensor Location button.
4. Tap the Controller button to select the indoor temperature sensor of the controller.
5. Tap the Indoor Unit button to select the indoor temperature sensor of the indoor unit.
NOTE - If more than one indoor unit is controlled by this controller, the room temperature sensor
location is permanently set to Controller and cannot be changed.
NOTE - If fresh air is being supplied directly to the indoor unit, Controller should be selected.
Figure 60. Set Room Temperature Sensor Location
55