Weather Sensor Status - Rain Bird ESP-LXME Installation, Programming & Operation Manual

Weather Sensor Status

g b
Turn the controller dial to Test All Stations/Check System.
A
The Check System screen appears. Press the Down Arrow button
to select Wthr Sensor Status; then press Next.
B
The Weather Sensor Status screen appears, showing the status of
the installed weather sensor.
1
28 ESP-LXME Controller
2
The sensor will display one of five status conditions:
a. Monitoring - sensor is active monitoring current weather
conditions.
b. <Inactive> installation has not been completed or the sensor is
not linked to any stations.
c. PAUSING - current weather condition has caused the sensor to
pause irrigation.
d. PREVENTING - current weather condition has caused the sensor
to prevent irrigation.
e. BYPASSED - sensor switch is in the Bypassed position and the
sensor is not monitoring current weather conditions.
b b
NOTE: If current weather conditions are sufficient for the weather
sensor to prevent or pause irrigation, then a message appears on
the Auto screen. This is not considered an alarm, so the controller
alarm light will not illuminate.