Table of Contents
Advertisement
I
The Delay to Re-Enable screen appears, allowing you to select
how long (from 0 minutes to 24 hours) before your system is re-
enabled to allow watering. If the flow condition still exists, SEEF or
SELF will shut down the system again. Selecting the default of 0
minutes configures the controller to stay shut down until the flow
alarm is manually cleared.
Press the + and – buttons to set hours before Re-Enable; then
press Next.
l Press and HOLD buttons to accelerate settings for hours and
b
minutes.
J
Press the + and – buttons to set minutes before Re-Enable; then
press Next.
i
b
b
NOTE: SEEF and SELF settings are not active until FloWatch is
activated.
62
ESP-LXME Controller
j
Advertisement
Chapters
Table of Contents
