Install Station Module - Rain Bird ESP-LXME Installation, Programming & Operation Manual

Install Station Module

Install the station module in Slot 1 that was included with your ESP-LXME
controller. Additional station modules can be purchased separately.
ESP-LXM -SM8 Station Module
ESP-LXM-SM12 Station Module
d b
CAUTION: Be careful not to bend the pins in the sockets when
installing a module.
A
Orient the connector on the bottom of the station module with
the connection socket in Slot 1 on the controller backplane. (An
ESP-LXM-SM8 is shown.)
1
B
Carefully fasten the module onto the controller backplane,
pressing firmly until it snaps into place. The red light on the module
will flash on and off once if the module is installed correctly. If the
light does not flash once, verify the module is seated correctly.
2
b b
NOTE: To remove a module, press in on the (two) release buttons
on either side of a module.
ESP-LXME Controller 103