Table of Contents
Advertisement
Mount Controller
A
Using a level, tape the mounting template to the mounting
surface at approximately eye level. Make sure that at least one of
the five mounting hole marks is aligned on a wall stud or other
solid surface.
B
Use a tapping tool (or nail) and hammer to tap pilot holes through
the five mounting hole marks and into the mounting surface.
Then remove the template and drill holes in the mounting surface,
installing wall anchors if necessary.
1
b
b
NOTE: If the controller needs to be mounted on an uneven
surface like stucco, place (or install) a section of exterior plywood
between the controller and the wall.
98
ESP-LXME Controller
C
Drive the first screw into the topmost-center hole. Then hang the
controller on the screw by the key-hole slot on the back of the
cabinet.
D
Line up the controller cabinet mounting holes with the remaining
pilot holes and drive the four remaining screws through the
cabinet back plane into the mounting surface.
3
2
5X
4
4X
Advertisement
Chapters
Table of Contents
