Panasonic KX-HTS824 Getting Started page 11

•
If damage to the unit exposes any internal parts, disconnect the power supply cord immediately and
return the unit to your dealer.
•
To prevent fires, electric shock, injury, or damage to the product, be sure to follow these guidelines when
performing any wiring or cabling:
a.
Before performing any wiring or cabling, unplug the product's power cord from the outlet. After
completing all wiring and cabling, plug the power cord back into the outlet.
b.
When laying cables, do not bundle the product's power cord with the power cords of other devices.
c.
Do not place any objects on top of the cables connected to the PBX.
d.
When running cables along the floor, use protectors to prevent the cables from being stepped on.
e.
Do not run any cables under carpeting.
•
Unplug this unit from the AC outlet if it emits smoke, an abnormal smell or makes unusual noise. These
conditions can cause fire or electric shock. Confirm that smoke has stopped and contact an authorized
Panasonic Factory Service Center.
•
Make sure that the wall that the unit will be attached to is made of concrete or thick wood, and is strong
enough to support the unit (approx. 11 kg [24 lb]). Do not attach the unit to walls made from plasterboard
or thin plywood. Attaching the unit to areas where there are strong winds, or where shocks or vibrations
are frequent or strong, may lead to the product falling over.
•
Only use the wall-mounting equipment (screws and washers) included with the PBX.
•
The grounding wire of the AC cable has an effect against external noise and lightning strikes, but it may
not be enough to protect the PBX and to ensure electromagnetic compatibility. A permanent connection
between ground and the ground terminal of the PBX must be made.
•
Proper grounding (connection to ground) is very important to reduce the risk to the user of electrocution
or to protect the PBX from the bad effects of external noise in the case of a lightning strike.
•
Plug the power cord firmly into an AC outlet. Otherwise, it can cause fire or electric shock.
•
Be careful not to drop any components. Dropping components may damage them or cause an injury.
•
Make sure that the AC outlet is properly grounded, then securely connect the 3-pin AC plug including the
grounded pin.
•
A lithium battery is used in the main unit. There is a risk of explosion if the battery is replaced with an
incorrect type. Dispose of used batteries according to the manufacturer's instructions.
•
Operating near 2.4 GHz electrical appliances may cause interference. Move away from the electrical
appliances.
–
This equipment must be installed and operated in accordance with provided instructions and spacing
as possible must be provided between antenna and all person's body (excluding extremities of hands,
wrist and feet) during wireless modes of operation.
–
This transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.
•
Consult the manufacturer of any personal medical devices, such as pacemakers or hearing aids, to
determine if they are adequately shielded from external RF (radio frequency) energy.
–
For North America / Latin America except Brazil / Taiwan:
Wireless LAN features operate between 2.412 GHz and 2.462 GHz with a peak transmission power of
100 mW.
–
For all other countries / areas:
1.1 For Your Safety
Getting Started 11