Panasonic KX-HTS824 Getting Started page 52

3.2.8 Wall Mounting
Wall Mounting Procedures
CAUTION
Drive mounting screws into the wall. Be careful to avoid touching any metals laths, wire laths or metal
plates in the wall.
Mounting on a Wooden Wall
The included screws may be used when mounting the main unit on a wooden wall.
1.
Place the template (found on the last page of this manual) on the wall to mark the 2 screw positions.
Note
When you print out the template, the distance on the paper output may deviate slightly from the
indicated measurement. In this case, use the indicated measurement.
2.
Install the screws and washers (included) to the wall.
Note
•
As indicated above, do not tighten the screw fully.
•
The pull-out strength of the installation area must be at least 294 N (30 kgf) per screw.
•
Do not block the operations of the cabinet. Allow space of at least 20 cm (8 in) above and 10 cm
(4 in) at the sides of the cabinet.
•
Make sure that screw heads are the same distance from the wall.
•
Install the screw perpendicular to the wall.
•
Be careful not to drop the cabinet.
52 Getting Started
A
A Template
B 225 mm (8-7 / 8 in)
C
C Washer
Drive the screw to this point.
B