Connecting The Ev-Chip Unit To The User System Interface Board - Renesas E200F User Manual

Section 2 Connecting the Emulator to the User System
2.2.6

Connecting the EV-chip Unit to the User System Interface Board

• After checking the location of pin 1, connect the EV-chip unit to the user system interface
board.
User system
Figure 2.9 Connecting the User System Interface Board to the EV-chip Unit
Check the orientation of pin 1 before connecting parts.
Notes: 1. Connection of the signals differs depending on the MCU used.
2. For the method to connect the user system interface board to the user system, refer to
the user system interface board user's manual for each MCU.
Rev. 4.00 Feb. 18, 2009 Page 16 of 64
REJ10J1662-0400
EV-chip unit
Connector No.
EV-Chip Unit
Connector No.
User I/F Connector 1
(CN3)
User I/F Connector 2
(CN4)
Board
CAUTION
Board
Connector No.
UCN1
UCN2