2.2.7
Using the E200F Emulator as a Stand-Alone Unit
• If you are using the E200F emulator unit without connecting it to a user system, refer to table
1.3 in section 1.2, System Configuration, and make connections as shown in figure 2.10 until
the EV-chip unit becomes available.
When using the emulator as a
stand-alone unit
When connecting the emulator to
the user system
Figure 2.10 Connecting the E200F Emulator as a Stand-Alone Unit
Section 2 Connecting the Emulator to the User System
User system
Rev. 4.00 Feb. 18, 2009 Page 17 of 64
EV-chip unit
User system
interface board
REJ10J1662-0400