Munters VX55 Instruction Manual page 9

Step 8
Starting at the bottom of the cone, locate one of the guard tabs and put the guard tab through the guard slot
in the cone. See Figure 7B.
of the corresponding guard slots. Some force may be required to snap the last tab into the last slot, pull out
on the center of the cone while pushing in on the guard tab until it snaps into place.
Step 9
If installing your existing guard into the new cone, locate the flat guard mounting pads on the cone and drill
a 9 ⁄ " dia. hole in the center of each pad. Then insert existing guard into cone with the guard eyelets facing
32
away from you. Line up each eyelet with a hole in the guard pads. Secure guard to cone using (8) existing
Bolts and Nuts. See Figure 8A and 8B.
Guard Mounting
Pad
© Munters Corporation, August 2018
Then work up around the guard and install each of the other guard tabs in each
Figure 7B
Tighten all nuts at this time.
Fan Outlet
Figure 8B
Chapter 2
Cone
Guard
Guard Tab
Guard Tab
Guard Slot in cone
Guard Mounting Pad
Figure 8A
Guard
eyelet
Installation Instructions
Nut
Bolt
Guard
QM1190r7
9