To operate the Munters Drive Off/Variable with a 10-0V Signal, slide the 'RUN' switch, located on the circuit
board in the Munters Drive Box, to the 'OFF' position. Now wire an 'ON' command from the 'COMMON'
terminal to the input relay in the control and from the output of the control relay to the 'RUN' terminal in
the Munters Drive Box. Also, connect wires from the '0-10V IN' and '0-10V COMMON' terminals in the
Munters Drive Box to the 10-0V output in the control.
Control
Relay
10-0V
Output
In Control
WARNING:
Fan is designed to be operated with shutter in place. Do not apply power to fan without
shutter being installed.
© Munters Corporation, August 2018
Chapter 3
See Figure 13G.
'RUN' Switch
Circuit Board in Munters Drive Box
Munters Drive Box
Junction Box
(By Others)
Figure 13G
On/Off with Variable Speed Operation
Electrical Wiring
Munters Drive Box
QM1190r7
19