Munters VX55 Instruction Manual page 15

When making connections to Munters Drive Box, be sure to use the supplied watertight fittings with only
1 cable per fitting. If watertight fittings are not used or if 2 cables or more are in 1 watertight fitting,
equipment failure from water damage will not be covered under warranty. If 2 or more cables are used in
1 watertight fitting, they must be sealed on both sides of Munters Drive Box wall to prevent water infiltration.
If you are going to run the Munters Drive with a signal from a control, carefully remove 6 screws and the
cover and save to reinstall later. Carefully punch the knock-out from the bottom of the Munters Drive Box and
install the Watertight connector as shown.
Munters Drive Box
Figure 13B
© Munters Corporation, August 2018
See Figure 13B and 13C.
Screw
Munters Drive Box Cover
Knock-out
Chapter 3 Electrical Wiring
Munters Drive Box
Watertight Connector
Figure 13C
15
QM1190r7