Chapter 3
Electrical Wiring
3.3 Recommended Wiring
The Munters Drive fan ships configured for simple ON/OFF operation. When electrical power is applied to
the main cable and the 'RUN' Switch is in the 'ON' Position, the fan will start and run at full speed.
See Figure 13A.
The Blue Box electrical enclosure must not be
removed from mounting bracket. Removing
Blue Box from the mounting bracket will void the
warranty. Any water or other damage to the
controller will not be covered if the Blue Box is
removed.
14
QM1190r7
Figure 13A
Default Operation Full Speed
***WARNING***
'RUN' Switch
Circuit Board in Munters Drive Box
***NOTE***
All Low Voltage wire must be shielded
cable. i.e. Belden 8770 or equivalent.
© Munters Corporation, August 2018