Pppoe - Value-Top VT-1104WL User Manual

USER MANUAL
automatically all the network parameters for your DVR. Unless the network is manually addressed
below parameters:
Address: The IP address identifies the DVR in the network. It consists of four groups of
IP
numbers between 0 to 255, separated by periods. For example, "192.168.001.100".
Mask: Subnet mask is a network parameter which defines a range of IP addresses that
Subnet
can be used in a network. If IP address is like a street where you live then subnet mask is like a
neighborhood. The subnet address also consists of four groups of numbers, separated by periods.
For example, "255.255.000.000".
Gateway: This address allows the DVR to access the Internet. The format of the Gateway
address is the same as the IP Address. For example, "192.168.001.001".
DNS1/DNS2: DNS1 is the primary DNS server and DNS2 is a backup DNS server. Usually should
be enough just to enter the DNS1 server address.

5.4.4.1 PPPoE

This is an advanced protocol that allows the DVR to connect to the network more directly via DSL
modem.
Check the "Enable PPPOE" box, and then enter the User name & Password of the PPPoE.
Click Apply to save, system will reboot to active the PPPoE setting.
52