Ptz; Ptz Control - Value-Top VT-1104WL User Manual

USER MANUAL

5.1.4 PTZ

This menu allows you to configure the PTZ (Pan-Tilt-Zoom) settings for the dome camera
Channel: Channel name
Signal Type: Analog for analog channels, Analog & Digital for IP channels.
Protocol: Choose the communication protocol between the PTZ capable camera and DVR. If
your camera support UTC (Up the Coax) function, you can choose COAX1 or COAX2 to display
your camera OSD menu or control the UTC PTZ function.
Baudrate: The speed of the information sent from the DVR to the PTZ-capable camera. Make
sure it matches the compatibility level of your PTZ-capable camera.
DataBit / StopBit: The information between the DVR and PTZ-capable camera is sent in
individual packages. The DataBit indicates the number of bits sent, while the EndBit indicates the
end of the package and the beginning of the next (information) package. The available parameters
for DataBit are: 8, 7, 6, 5. the available parameters for the StopBit are 1 or 2.
Parity: For error check. See the documentation of your PTZ-capable camera, to configure this
setting.
Cruise: Enable to use the Cruise mode. In order to use the Cruise mode, you need to set a
number of preset points.
Address: Set the command address of the PTZ system. Please be noted that each PTZ-capable
camera needs a unique address to function properly

5.1.4.1 PTZ control

After finishing the PTZ setup, you can use the PTZ function to control your PTZ camera.
1) Click left your mouse upon a channel on Live Viewing screen to open Camera Quick Toolbar,
and choose the PTZ control icon .
24